Installation Guide

11
7 CUSTOM DOOR PANEL INSTALLATION DIMENSIONS — RS36A72
Dimensions apply for the preparation and installation of custom door panels. For Dwg and Dxf files of the below panel preparation download the folder on thekitchentools.fisherpaykel.com.
Ø 3/32" (2mm) REF
10x Pilot holes recommended
forbracket attachment.
(Do not penetrate front surface).
153/16" (385mm)
51/16"
(128mm)
11/8"
(29.1mm)
37/16"
(87.2mm)
193/8" (492mm)
215/16" (542mm)
163/8" (416mm)
All measurements to be made
from top and centerline.
BOTTOM PANEL — REAR VIEW
Cut outs are located in attachment bracket for Fisher & Paykel handles only.
Iflocating custom handle in the shaded area above, ensure handle screw heads
are counter sunk into back of panel to avoid interference with hanging bracket.
Ensure handle is mounted
29/16" (65mm) from inner edge
of panel to the center — this will
avoid interference with brackets.
13/8" (34.7mm)
165/16" (414mm)
23/16" (54.8mm)
415/16" (126.1mm)
615/16" (176.1mm)
2415/16" (633.6mm)
2615/16" (683.6mm)
385/8" (981mm)
40" (1016mm)
Ø 3/32" (2mm) REF
12x Pilot holes recommended for bracket attachment.
(Do not penetrate front surface).
157/16" (392.3mm)
TOP PANEL — REAR VIEW
All measurements to be made
from inner bottom corner.
Forthe second panel mirror
and repeat dimensions using
inner bottom corner as the
reference point.