Installation Guide

35
Adjust the door panels
1
Push the appliance into the cavity until the door panels are flush
with adjacent cabinetry.
2
Place a ruler on the front of the appliance to check flushness top
and bottom, left and right.
IMPORTANT!
●
Follow these steps to avoid difficulties in door panel adjustment and cosmetic cap fitment.
@0 DOOR PANEL INSTALLATION — CUSTOM
2
Each door panel has full axis adjustment to ensure flushness
with adjacent walls. To adjust the height of the panel, turn
the stud clockwise to raise or counter-clockwise to lower the
door panel (A).
3
Once satisfied with the alignment, secure M8 studs with M8
washer and M8 nut (B). The top of the stud must remain below
the top face of the door panel.
4
Secure side bracket forks by tightening
side screws(C).
Repeat for all door panels.
Note:
– For depth adjustment, loosen the
side screws, adjustthe panels and
then retightenoncesatisfied.
– Further adjustment of door panels
can be achieved by removing door
panels then looseningthe fixing
screws for the hanging bracket and
moving the bracket sideways to suit.
5
Loosen the M8 stud (D) so that locking
bracket can slide freely back to front.
– Slide the locking bracket out until it
touches the back of the door panel.
Fully tighten the M8 stud.
– Screw in place using a #8x16 screw
through one ofthe three slotted
holes.
C
B
A
D
B
Door panel
attachment
kit
#8 x 16 Mush Washer Twin Thread Philips Screw
#8 x 16
Mush Washer
Twin Thread
Philips Screw
#8Gx16 countersunk
screw (2)
Tools
Hex key
FPA spanner
Cross-head screwdriver
Powered driver (optional)
Ruler