Use and Care Guide
30
WATER FILTER  
(ICE & WATER AND AUTOMATIC ICE MODELS ONLY)
To reset the filter indicator
IMPORTANT!
We recommend the water filter to be used from the time of installation.
Do not reset indicator before filter is changed or filter monitoring will be inaccurate.
Press and hold  and   for 4seconds to reset the internal and external filter indicators.
The   icon on the internal and external displays will turn off when reset.
To disable the filter indicator
Note: if disabled, you will not be reminded to next change your filter.
When no filter is fitted, you can disable the filter indicator.
Press and hold    and   for 4seconds to turn this feature off, the   icon will flash 
once on the internal and external displays. 
We recommend that you do not disable the filter indicator if you have a filter fitted to 
the connection.
To turn this feature on press and hold    and   for 4seconds, the   icon on the 
internal and external displays will flash twice. 
IMPORTANT!
To avoid serious illness or death, do not use the water filter where water is unsafe or 
of unknown quality.
The water filter cartridge needs to be changed when the filter indicator icon flashes 
on the interface panel.
We recommend the water filter cartridge is replaced when the internal and external  
 icons illuminate. This will happen every 6months.
If the water filtration system has been allowed to freeze, replace filter cartridge.
The rate of water flow through the water dispenser can slow down as the filter 
cartridge accumulates any sediments which may be present in the water supplied to 
your home. This varies depending upon your local water quality, which may require 
your filter cartridge to be changed more frequently.
In cases of excessively reduced filter life we recommend that you consult a local 
plumber or your water supplier for advice on suitable filtration requirements for the 
water supplied to your home.
Filter replacement is the consumer’s responsibility and will not be covered by the 
warranty except in the case of faulty parts or materials within the filter cartridge.
If the water has not been dispensed for some time or water has an unpleasant taste or 
odor, flush system by dispensing 4qt (4L) of water.
If unpleasant taste or odor persists, you may wish to fit a new filter cartridge.










