Use and Care Guide
17
INSTALLATION INSTRUCTIONS
Before you start using the Ice & Water or Automatic Ice function
Check your refrigerator is switched on.
Check that the isolation tap has been connected and turned on.
Allow at least 2hours for your refrigerator to cool before use.
For Ice & Water models only:
Run through and discard the first 1 gal (4L) of water from your water dispenser,
stopping intermittently to remove trapped air in the system. Failure to do this will result
in excessive dripping from your dispenser. Note: there will be a 1–2 minute delay while
the tank fills until water is dispensed.
For Ice & Water and Automatic Ice models:
Turn the ice maker on by pressing the button. The light above the button will be
illuminated when the ice maker is on.
Press and hold the , and buttons together for 4seconds and then close the
refrigerator compartment door to force an ice maker cycle. The ice tray will flip twice.
Repeat to force another ice maker cycle. The ice tray will flip twice and spill water into
the ice bin. Empty the water, dry and replace the bin. Note that the ice tray will not flip
until the refrigerator compartment door is closed.
Please discard the first 3harvests of ice (8cubes per harvest).
You are now ready to enjoy water and/or ice from your ActiveSmart™ refrigerator.
Please note that once installation is complete a few drips may appear out of the
dispenser over the next few days as the remaining trapped air is cleared.
Water dispenser