Installation Guide
Table Of Contents
- Safety and warnings
- Parts supplied for installation
- Product dimensions – 30" models
- Product dimensions – 36" models
- Product dimensions – 48" models
- Clearance dimensions – all models
- Backguard considerations
- Ventilation requirements
- Unpacking the range
- Removing and refitting the oven door(s)
- Location of electrical and gas supply
- Electrical connection
- Gas connection
- Toe kick installation
- Levelling the range
- Cooktop burners
- Leak testing
- Installing the anti-tip bracket
- Final checklist
12
3. REMOVE FROM PALLET
1. REMOVE TOE KICK 2. REMOVE DOORS
UNPACKING THE RANGE
1
1
2
3
1
2 2
Remove both screws to detach
the toe kick from the range.
Open the door completely and
open the hinge locks fully on
both sides. Refer to page 13 for
more detail
Lift toe kick up and rotate
towards you to remove.
Remove front bolts
Remove the two shipping
bolts made visible by
removing the toe kick.
Remove lower guard
Unscrew the lower guard
panel from the back of
the range to remove.
Remove rear bolts
Remove the two shipping
bolts made visible by
removing the lower guard.
Holding the door on both sides,
lift door back up to 45° and
carefully pull the door out and
away from the hinges.
Before restraining the product to the
hand truck, place two cardboard packing
sheets (shipped with the product)
against both side panels as shown.
Tilt the product and insert hand truck.
DO NOT insert the hand truck to the
front of the product.
Restrain the product and packing sheets
to the hand truck using straps and tilt
onto hand truck. Set pallet aside and pull
product to the installation location.
packing sheet
packing sheet
restraining
strap
IMPORTANT!
Two people required.
FRONT VIEW HINGE DETAIL
PROFILE VIEW PROFILE VIEW