Installation guide

BEFORE YOU START
PAGE 2 OF 8
Correct installation is the responsibility of the customer.
Ensure that the installer is properly qualified to install this oven.
= Make surethat the oven is locatedaway from any strong and/or hot draftsof air,
• Thecabinet openingdimensionsspecifiedare the absoluteminimum. Thesedimensionsallow a clearance
of upto 1/4"(6mm).
° The productmust beelectrically grounded.See"ElectricalConnection"for details,
* We recommendthat the electricalsupplyjunction box is locatedeither 3" below the mainsupportsurface of
the productonthe right handside or flush mountedinthe rear wall behindthe productor mountedin the
adjacentright-handside cabinet. A 1" diameterholeshouldbe drilledin the right rearcornerof the oven
cabinetor in the rearof the right-handsidewall as requiredto enablethe electricalsupply cord to be passed
through the cabinetto the junction box, Detailsof these requirementsare shownin thediagramto the right.
* Theoven supportsurfaceshould beflat, level and beableto supporta weight of at least 420 pounds(190 Kg)
for a doubleovenand 238 pounds(108 Kg)for singleovenmodels,
• Youwill needa No,2 Phillipsscrewdriverto completethe installationof the oven into the cabinet.
Thereshould be 4 suitablewood screws with this installationkit (Part number556075)and4 spacers
(Partnumber 545455),
* A Fisher8 PaykelCE901cooktop can be installedabovean 0S301single wall oven if a 3/8" (10mm)gap is
providedbetweenthe top of the oven andthe bottomof the cooktop.
It is the customersresponsibility:
• It is the customersresponsibilityto ensurethat the product is electricallyconnectedby a qualified
electrical installerin conformancewith the NationalElectricalcode, ANSI/NFPA70 (latest edition)and
all local codes andordinances,
Junction Box
location for
undercounter
--installation
Junction Box
-- location for wall
installation
Copiesof the standardslisted may beobtainedfrom
* NationalFireProtectionAssociation
BatterymarchPark,Quincy,Massachusetts02269