User Guide
Table Of Contents
- User Guide
- Contents
- Safety and warnings
- Introduction
- First use
- Cooking guide
- Oven functions
- Cooking charts
- Setting the timer
- Auto Cook
- Locking the oven controls
- User preference settings
- Sabbath Mode
- Using your induction cooktop
- Locking the cooktop controls
- Using your cooktop’s special features
- Choosing the right cookware
- Cooking guidelines
- Using the storage drawer
- Care and cleaning
- Troubleshooting
- Alert codes
- Warranty and service
51
USING YOUR COOKTOP’S SPECIAL FEATURES
If no pan is detected on one cooking zone:
The front cooking zone display will still show the selected temperature and the rear cooking
zone display will still show
.
If after 10 minutes no pan is detected:
z
the bridging function will switch off
z
the cooking zone without a detectable pan will continue to show
z
the remaining cooking zone will continue cooking at the selected heat setting.
Using Auto RapidHeat in bridged mode
1 Bridge the cooking zones.
2 Turn the control dial for the front cooking zone back past OFF to A.
3 Hold the dial at A until
starts alternating in the display.
4 Turn the control dial to your selected heat setting. the Heat setting and
will alternate
in the display.
5 The bridged zone is now set for Auto RapidHeat.
To cancel bridging
Turn both control dials back to OFF.