Installation Guide

12
INSTALLING THE ANTI-TIP BRACKET
Fit the anti-tip bracket
1 Loosely fix the anti-tip bracket to the wall using the supplied screws.
z
Drill two 8mm diameter holes in the wall and insert the supplied plastic
sleeve anchors before inserting the screws.
2 Slide the cooker into place and adjust the height of the bracket
sothat it will align with the slot on the back of the cooker.
3 Tighten the screws to fix the anti-tilt bracket in place.
4 Push the cooker back into place so that the bracket is fully inserted
into the slot on the back of the cooker.
min 67mm
max 217mm
IMPORTANT!
z
To restrain the cooker and prevent it tipping accidentally secure the cooker to the wall using the supplied anti-tip bracket.
Ensure you also fit the supplied lock pin to the anti-tip bracket.
z
If installing the cooker above a plinth (without fitting the adjustable feet) revise the installation dimensions for the anti-tip
bracket accordingly, considering that the feet have the following measurements: min 85mm–max 133mm.
z
Before drilling and holes or inserting any screws into the floor or wall check that you will not damage any wiring or pipes.
40mm
dotted line showing the
position of the range
when installed
anti-tip bracket
bracket
slot at
back of
the range