Installation Guide

16
gas inlet pipe
connector
GAS CONNECTION
1 Before connecting the appliance to the gas main,
fitthe female connector to the left inlet pipe using
thefibre washer supplied. Ensure connector is
positioned as shown above.
3 A restraining chain (not supplied) must be
attached securely to the cooker and the rear wall.
This is used to prevent stress being applied to the
gas hose orpipework.
IMPORTANT!
z
The connection must be performed by an authorised person
according to the relevant standards.
z
The gas supply must use the gas inlet pipe which is located
at the left hand side at the rear of the appliance.
20mm
10mm
10mm
20mm
IMPORTANT!
Use two wrenches to tighten the connection.
2 Tighten the connection between the inlet pipe
and connector. Once tightened, fit the hose to the
connector. Ensure the hose is not crushed, trapped
or in contact with sharp or abrassive edges or
subjected to corrosion by acidic cleaning agents.
The hose should also be connected in such a way
that it does not touch the floor and must hang
in a natural loop between the appliance and the
bayonetfitting.