Installation Guide
12
INSTALLING THE ANTI-TIP BRACKET
Fit the anti-tip bracket
1 Loosely fix the anti-tip bracket to the wall using the supplied screws.
z
Drill two 8mm diameter holes in the wall and insert the supplied plastic
sleeve anchors before inserting the screws.
2 Slide the cooker into place and adjust the height of the bracket
sothat it will align with the slot on the back of the cooker.
3 Tighten the screws to fix the anti-tilt bracket in place.
4 Push the cooker back into place so that the bracket is fully inserted
into the slot on the back of the cooker.
IMPORTANT!
z
To restrain the cooker and prevent it tipping accidentally secure the cooker to the wall using the supplied anti-tip bracket.
Ifinstalling the cooker above a plinth (without fitting the adjustable feet) revise the installation dimensions for the anti-tip bracket
accordingly, considering that the feet have the following measurements: min 85mm–max 133mm.
z
Before drilling and holes or inserting any screws into the floor or wall check that you will not damage any wiring or pipes.
z
When sliding the cooker back into place take care not to trap the power supply cable or gas connection hose in the anti-tip bracket.
min 67mm
max 217mm
40mm
dotted line showing the
position of the range
when installed
anti-tip bracket
bracket
slot at
back of
the range