Installation Guide

When you install the oven
Do not seal the oven into the cabinetry with silicone or glue. This makes future servicing difficult. Fisher &
Paykel will not cover the costs of removing the oven, or of damage caused by this removal.
Use the supplied screws to secure the oven to the cabinetry. Do not over-tighten the screws.
Make sure that the
p
ower su
pp
l
y
cable will not touch an
y
hot metal
p
arts.
Important!
SAVE THESE INSTRUCTIONS
The models shown in this document may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please visit our local
website listed at the end of this document or contact your local Fisher & Paykel dealer.
SAFETY AND WARNINGS
1
Before you install the oven, please make sure that
it will be lifted by two people.
the oven will rest on a flat surface that can support its weight.
the benchtop and oven cavity are square and level, and are the required dimensions.
the hei
g
ht from the floor suits the customer.
WARNING!
Electrical shock hazard
Always disconnect the appliance from
the mains power supply before
carrying out any maintenance or repairs.
Connection to a good earth wiring
system is essential and mandatory.
Alterations to the domestic wiring
system must only be made by a
qualified electrician.
Failure to follow this advice may result
in electrical shock or death.
WARNING!
Fire hazard
Do not use adapters, reducers, or
branching devices to connect this
appliance to the mains power supply.
Failure to follow this advice may result
Important safety instructions!
To avoid hazard, follow these instructions carefully
before installing or using this appliance.
Please make this information available to the
person installing the appliance - doing so could
reduce your installation costs.
This appliance must be installed and connected
to the mains power supply only by a suitably
qualified person according to these installation
instructions and in compliance with any applicable
local building and electricity regulations. Failure to
install the appliance correctly could invalidate any
warranty or liability claims.
The oven must be earthed.
If the power supply cable is damaged, it must be
replaced by the manufacturer, its service agent or
similarly qualified person in order to avoid a hazard.
WARNING!
Cut hazard
Take care - panel edges are sharp.
Failure to use caution could result in
injury or cuts.
NZ AU GB IE
MULTIFUNCTION OB90 OVENS
(2,2) -2- 599790H OB60&OB90 installA2 NZGB.indd 25/09/17 12:33 PM
(2,2) -2- 599790H OB60&OB90 installA2 NZGB.indd 25/09/17 12:33 PM