Installation Guide

9
!1 SECURE THE OVEN TO THE CABINETRY
!2 REFIT THE DOOR
IMPORTANT!

Do not lift the oven by the door handle.

Do not over-tighten the screws.

Do not seal the oven into the cabinetry with silicone or glue. This makes future
servicing difficult. Fisher & Paykel will not cover the cost of removing the oven, or
damage caused by this removal.
1 Position the oven in the prepared cavity.
2 Open the oven door fully.
3 Secure oven to cabinetry using supplied screws.
2.5 mm
IMPORTANT!

Always keep a safe distance from the door hinges, paying special attention to position of your hands.

If the door hinges are not correctly hooked, they could unhook and close suddenly and unexpectedly with risk of injury.

Take care, the oven door is heavy.
3 Open the door to its fullextent.1 Hold the door firmly.
Close the
levers
4 Fully close the levers on the
left and righthinges.
5 Close the door and check
that it is properly in place:
it should sit square to the
controlpanel.
2 Insert the hinge tongues
into the slots, making
sure that the notches
on both sides drop into
place as shown.
Notch