User Guide

Removing and replacing the sliding shelves and side racks

1 To remove a sliding shelf, grip it by its two front corners (making sure you are gripping

the wire shelf and the sliding frame together), tilt upwards and pull it out of the oven.

2 To remove the side racks, gently push the retaining wire from underneath the lock stud,

then swing the lowest edge of the side rack up and out towards the center of the oven

until the rack is almost horizontal. The prongs at the top will slide out of the mounting

slots.

3 To replace the side racks, hold them almost horizontally and locate the prongs into the

small mounting slots at the top of the oven cavity. While you are doing this, support the

rack with your hand from underneath, to ensure that both prongs perfectly locate into

the mounting slots.

4 Lower the side racks carefully and gently place the retaining wire underneath the lock

stud.

IMPORTANT!

Do not lower the side racks until the prongs are fully inserted into the slots so that

you do not chip the enamel.

Mounting slots

Retaining wire

Lock stud

CARE AND CLEANING