Installation Instructions

1/16"
Fig. 05
7. Place the right and left mounting bracket supports by resting the bottom edges of the supports
on the bottom of the cutout
(Fig 04). The long flange on the side supports should clear the side
of the cutout by approximately 1/16” (Fig. 05). Install top and bottom screws into the cabinet face
by first drilling 1/8” pilot holes (see inserts 3 and 4).
8. Install trim kit face by inserting top pins of trim into corresponding sockets on the top corners
of clip support plates (see insert 1).
9. Finish the
assembly by inserting the bottom pins into the corresponding sockets on front edge
of the base (see insert 3). Check for proper door opening clearances.
Fig. 04
Bracket
Support
on the
bottom
of cutout