INSTALLATION INSTRUCTIONS USER GUIDE Tilted wall cooker hood HT90GHB2 model GB IE
CONTENTS Introduction 3 Safety and warnings 4 Installation instructions 8 About your cooker hood – Energy efficiency 18 Operating instructions 19 Cleaning and maintenance 20 Parts and accessories 22 Manufacturer’s Warranty 23 Customer Care 24 Important! SAVE THESE INSTRUCTIONS The models shown in this user guide may not be available in all markets and are subject to change at any time.
introduction Thank you for purchasing a Fisher & Paykel product. Thousands of hours go into the design, engineering, testing and perfecting of each Fisher & Paykel appliance. The care and attention given to creating these beautiful products doesn’t stop once it has found its home with you.
Safety and warnings ! WARNING! Weight Hazard The cooker hood is heavy. Please ensure adequate care is taken when installing the cooker hood to prevent personal injury. The 34.5 kg cooker hood must be installed onto a solid wall, stud, beam or truss. Weight of the product is 34.5 kg. ! WARNING! Electric Shock Hazard Always disconnect the appliance from the mains power supply before carrying out any maintenance or repairs.
Safety and warnings • • • • • • • and in compliance with any applicable local building and electricity regulations. Failure to install the appliance correctly could invalidate any warranty or liability claims. If the power supply cable is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard. To comply with electrical safety regulations, this cooker hood must be connected to a socket near the appliance.
Safety and warnings • When the cooker hood is turned on at the same time as other appliances powered by energy other than electricity, the air outlet must not be greater than 4 Pa (4x10-5 bar). • The minimum distance between the hob surface and the base of the cooker hood shall be 400 mm or 650 mm if installed over a gas hob. • Stainless steel is very easily damaged during installation if abraded or knocked by tools.
Safety and warnings • During climatic conditions causing electrical interference, it is possible that the device may stop working. By switching the device off and on the device will resume normal operation safety. • During an electrostatic discharge (ESD) it is possible that the device will stop working. By switching the device off and on the device will again work as intended. There is no risk and no risk will appear. • CAUTION: accessible parts may become hot when used with cooking appliances.
INSTALLATION INSTRUCTIONS Unpacking your cooker hood 1 2 3 4 5 8 6
INSTALLATION INSTRUCTIONS Contents of packaging INSTALLATION INSTRUCTIONS USER GUIDE Tilted wall cooker hood HT90GHB2 model GB IE Cooker hood (1) Installation instructions User guide manual (1) Chimney (1) Upper chimney (1) Chimney bracket (1) Upper chimney bracket (1) 60 mm screws and wall plugs (6) 30 mm screws and wall plugs (4) 10 mm screws (4) 9
INSTALLATION INSTRUCTIONS Product dimensions H g Ø I Power cord location F E A max A min D C B K 10 J
INSTALLATION INSTRUCTIONS HT90GHB2 Product Dimensions A Overall height of product mm 800 – 1140 B Overall width of product 900 C Overall depth of product 380 D Height of hood 520 E Width of flue 320 Depth of flue 290 F G Distance from centre of ducting outlet to back of product 140 H Distance from centre of ducting outlet to side of flue 160 I Diameter of ducting outlet 150 J Distance between centre of lights K Distance from centre of lights to back of product Length of power cord 200
INSTALLATION INSTRUCTIONS Height of cooker hood L M minimum clearances L Installation height Ducted Recirculation M Height top of hob to base of product Electric hob Gas hob 12 mm min. 840 – max. 1140 min. 880 – max. 1140 min. 400 min.
INSTALLATION INSTRUCTIONS Venting options Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air are fulfilled. The cooker hood can be installed to operate with the exhaust air ducted externally from the kitchen, or installed to operate with the exhaust air recirculating within the kitchen. Ducted For ducted installation it is recommended that 150 mm diameter, rigid or semi-rigid ducting is used.
INSTALLATION INSTRUCTIONS Installation WARNING! This product is heavy and requires two persons for installation. Warning! Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. The manufacturer is not liable for any damage caused by not following these instructions. 1 Preparing for installation: Before installing your cooker hood: ●● Please read the instructions carefully. ●● Unpack the hood and check all functions are working.
20 mm INSTALLATION INSTRUCTIONS 250 mm 235 mm Upper chimney bracket attachment points Chimney bracket attachment points Upper hood attachment points 773 mm 240 mm Internal hood attachment points 250 mm 155 mm 365 mm 501 mm 270 mm Fig.
INSTALLATION INSTRUCTIONS Fig.
INSTALLATION INSTRUCTIONS 3 Attach hood to wall ●● Open the front panel on the hood and remove the filter as shown in figures 4 – 6. Fig.4 ●● Fig.5 Fig.6 Hang hood off upper hood mounting screw with 2 mm gap. Hang off the keyhole attachment points on the back of the hood (see Fig.7). Tighten screws. Fig.7 ●● ●● Attach internal hood mounting screws to fix hood to wall. Use the 60 mm screws. Reattach filter and close front panel.
ABOUT YOUR Cooker hood – ENERGY EFFICIENCY Product Fiche EN61591 Model Annual Energy Consumption (kWh/annum) Time Increase Factor 32.2 1 Energy Efficiency Index 52.8 Energy Efficiency Class A Fluid Dynamic Efficiency Fluid Dynamic Efficiency Class Lighting Efficiency Lighting Efficiency Class Grease Filtering Efficiency Grease Filtering Efficiency Class 28.5 A 28.7 A 91.2 B Airflow at Min. Speed (m³/hr) 200 Airflow at Max.
OPERATING INSTRUCTIONS Touch control panel control panel features Increase lighting level Press once to adjust the light to the highest level. The icon illuminates red when on the highest level. Press and hold to progressively increase the light level. Reduce lighting level Press once to adjust the light to the lowest level. The icon illuminates red when on the lowest level. Press and hold to progressively dim the light level. Lights on/off Turn the lights on or off.
Cleaning and maintenance Important! Never use abrasive or oil based cleaners Maintenance Before performing any cleaning or maintenance on your cooker hood, ensure that the power supply is switched off to the hood. The cooker hood should be cleaned regularly using a mild, liquid detergent to avoid a build-up of grease occurring. Grease deposits are corrosive which can damage your cooker hood. Note: in areas of high humidity or coastal environments, cleaning should be carried out frequently.
Cleaning and maintenance Carbon filter – for use in recirculation mode Active carbon filters are disposable items designed to remove grease and odours from cooking vapours before the air is channelled back into the kitchen. The active carbon filter must be replaced periodically to work properly, at least once every three months, depending on the frequency of use of the cooker hood. Note: fully saturated carbon filters can become a barrier to air movement therefore limiting cooker hood performance.
Parts and accessories 22 item reference Number LED bulb x2 792556 Aluminium filter 791761 Recirculation carbon filter 50031 Recirculation diverter 50032 Ducting 150 mm kit (eaves) 50033 Ducting 150 mm kit (wall) 50034
Manufacturer’s Warranty You automatically receive a 2 year Manufacturer’s Warranty with the purchase of this Tilted wall cooker hood covering parts and labour for servicing within the United Kingdom and Ireland. Fisher & Paykel undertakes to: Repair or, at its option, replace without cost to the owner either for material or labour any part of the product, the serial number of which appears on the product, which is found to be defective within TWO YEARS of the date of purchase.
customer care Before you call for service or assistance... Check the things you can do yourself. Refer to your user guide and check that: 1 Your product is correctly installed. 2 You are familiar with its normal operation. If after checking these points you still need assistance or parts, please refer to your nearest Authorised Service Centre, Customer Care, or contact us through our local website listed on the back cover.
customer care Complete and keep for safe reference: Model Serial No.
www.fisherpaykel.com Copyright © Fisher & Paykel 2015. All rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your dealer to ensure this booklet correctly describes the product currently available. GB IE 104041 A 04.
