Installation Guide

2
2 PARTS SUPPLIED
Clamp (1)
(for securing
Drain hose joiner)
Wire clip (1)
(for securing
Drain hose joiner)
Phillips
5/8” (16mm)
screws (7)
1 1/2” (38mm)
bottom fixing
screws & metal
washers (2)
Drain hose
support (1)
Moisture protection
tape (1)
(to prevent moisture
damage to cabinetry)
Cavity Bracket Kit (1)
(supplied with Fisher
& Paykel Tall Height
Models only)
Drain hose
joiner (1)
Top mounting
brackets (2)
OPTIONAL
Rubber washer
for inlet hose (1)
(comes already
fitted)
Side mounting
bracket kit
(A and B) (2)
OPTIONAL
Edge Protector (1)
(If the services hole
is through a metal
partition, the hole must
be protected with the
Edge Protector supplied
to prevent damage to the
power cord or hoses.)
If the Drain hoses supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit P/N 525798 which will extend the drain hoses by 11’ 10” (3.6m).
The kit is available from the nearest Fisher & Paykel Authorized Service Center, or Toll free 1.888.936.7872 or www.fisherpaykel.com
Dishdrawer installation overview
This video provides an overview of what is needed to install a DishDrawer™. It is intended as an overview only of the installation
process and is not intended to be used as a guide on how to install a DishDrawer™ yourself. https://vimeo.com/325297597