Installation Guide

7
6 CAVITY PREPARATION
Water Connection
Recommended HOT
(Maximum 140°F/60°C).
Supplied hose to
suit 3⁄8” (9 mm) male
compression fitting.
Kosher requirements
Drains will need to be
separated to satisfy
kosher requirements.
We suggest you confirm
acceptability with your
local rabbi in respect to
kosher installations.
Water Pressure
Water softener models
Max. 1 MPa (145 psi)
Min. 0.1 MPa (14.5 psi)
Models without water softener
Max. 1 MPa (145 psi)
Min. 0.03 MPa (4.3 psi)
IMPORTANT!
The power outlet must be
located in a cabinet adjacent
to the dishwasher cavity.
110-120 VAC max. 15 A
Service Holes
Can be located either side of dishwasher, close to the rear face and the
floor, as illustrated, for access to the water supply, drain and power outlet.
Thesmall hole is for the power cord only.
O
If the hole is through wood, make sure its edges are smooth androunded.
O
If the hole is through metal, ensure you fit the supplied Edge Protector to
prevent damage to the power cord.
These marks indicate formed
bracket screw locations, if
securing by drawer removal.
If there is no side partition, you
can construct timber bracing
as something to secure into.
Moisture
protection tape
must be applied.
3/8”
(10 mm)
COUNTERTOP
WARNING!
Incorrect placement of the hole
will result in damage to hoses.
Ø 2 1/4”
(57 mm)
Max 1/2” (10mm)
Max distance between
hole edge and floor
Max 1/4” (5mm)
Max distance
between hole edge
and rear inner face
max. 17 11/16”
(450 mm)
min. 7 7/8” (200mm)
Hoses
Power
cord
Ø max. 1 1/2”
(38 mm)