Quick Start Guide
Table Of Contents
- 1 Safety and warnings
- 2 Integrated columns
- 3 Components list
- 4 Product dimensions and specifications
- 5 Cabinetry options
- 6 Cavity dimensions
- 7 Door and toe kick panel dimensions
- 8 Custom door panel dimensions
- 9 Door opening rotation
- 10 Electrical and plumbing
- 11 Before installation
- 12 Unpacking and moving your product
- 13 Attach the anti-tip bracket
- 14 Connect to water and power supply
- 15 Single installation
- 16 Dual installation
- 17 Install water filter
- 18 Install brackets to door panel (Stainless steel)
- 19 Install brackets to door panel (Custom)
- 20 Install door panels
- 21 Install toe kick
- 22 Install kickstrip grille
- 23 Install cabinet trims
- 24 Install flow divider and door trims
- 25 Optional — Changing over door hinges
- 26 Final checklist
42
Required components/tools:
star T20 screwdriver
flat head screwdriver
Moving the sensor housing (RS18 & RS24 only)
@5OPTIONAL—CHANGING OVER DOOR HINGES
G
A
B
C
E
F
D
1 Unclip the reed switch from the housing (A).
2 Unhook the interceptor board harness from sensor
housing so harness is loose (B).
3 Remove the #8x16 screws (2x) from the sensor housing (C).
5 Reinstall the sensor housing using #8x16 screws (2x)
into the pre-drilled holes in the cabinet top panel (E).
6 Clip the reed switch into the sensor housing in the
pocket closest to the centerline of the cabinet (F).
7 Press the harness from the interceptor board into the
forks on the sensor housing (G).
4 Move the sensor housing so that the opposite reed switch
clip is aligned with the center of the cabinet (D).