Quick Start Guide
Table Of Contents
- 1 Safety and warnings
- 2 Integrated columns
- 3 Components list
- 4 Product dimensions and specifications
- 5 Cabinetry options
- 6 Cavity dimensions
- 7 Door and toe kick panel dimensions
- 8 Custom door panel dimensions
- 9 Door opening rotation
- 10 Electrical and plumbing
- 11 Before installation
- 12 Unpacking and moving your product
- 13 Attach the anti-tip bracket
- 14 Connect to water and power supply
- 15 Single installation
- 16 Dual installation
- 17 Install water filter
- 18 Install brackets to door panel (Stainless steel)
- 19 Install brackets to door panel (Custom)
- 20 Install door panels
- 21 Install toe kick
- 22 Install kickstrip grille
- 23 Install cabinet trims
- 24 Install flow divider and door trims
- 25 Optional — Changing over door hinges
- 26 Final checklist
34
@0INSTALL DOOR PANELS
Adjust the door panel
Note: All door panels have full axis adjustment to ensure they are flush with adjacent walls.
1 To adjust the height of the door panel relative to the door, use M4 hex key to turn the top
M8 screw (A) clockwise to lower or counter-clockwise to raise the door panel until the gap
with the cabinetry above is 1/8” (3mm).
2 To adjust the depth of the door panel, loosen the side screws (B) from each side and slide
the panel forward/backward. Re-tighten once satisfied.
3 To adjust the door panels further, remove the door panels then loosen the fixing screws for
the hanging bracket and move the bracket sideways to suit. (C)
4 Once satisfied with the door panel position, fully tighten M8 washer and nut to the stud
using a M4 hex key (A).
Fix the locking brackets
1 Loosen the screw at the bottom of the door, and slide the locking bracket out until it
touches the panel (D).
2 Fix the locking bracket to the door panel with 8Gx16 countersunk screw (E).
3 Re-tighten the screw at the bottom of door (F).
Required components/tools:
1x Phillips screwdriver
M4 hex key
1/2” (13mm) spanner
A
C
B
F
E
D