Quick Start Guide
Table Of Contents
- 1 Safety and warnings
- 2 Integrated columns
- 3 Components list
- 4 Product dimensions and specifications
- 5 Cabinetry options
- 6 Cavity dimensions
- 7 Door and toe kick panel dimensions
- 8 Custom door panel dimensions
- 9 Door opening rotation
- 10 Electrical and plumbing
- 11 Before installation
- 12 Unpacking and moving your product
- 13 Attach the anti-tip bracket
- 14 Connect to water and power supply
- 15 Single installation
- 16 Dual installation
- 17 Install water filter
- 18 Install brackets to door panel (Stainless steel)
- 19 Install brackets to door panel (Custom)
- 20 Install door panels
- 21 Install toe kick
- 22 Install kickstrip grille
- 23 Install cabinet trims
- 24 Install flow divider and door trims
- 25 Optional — Changing over door hinges
- 26 Final checklist
31
!8INSTALL BRACKETS TO DOOR PANEL (STAINLESS STEEL)
IMPORTANT!
Ensure to protect the finish of the Fisher & Paykel Stainless Steel door panels. Leave
the protective film on the panels when hanging and remove the film only when the
installation is complete.
Required components/tools:
Door panel attachment kit (847678)
– 6x side panel brackets (838183)
– 6x bracket slider (838201)
– 6x side spacer bracket (846177)
– 30x 8Gx16 mush washer screws
(840371) (for SS door panels only)
drill with 3/32” (2.55mm) bit
Phillips driver on battery drill
M4 hex key
1/2” (13mm) spanner
4 Align the screw holes of the bracket with the screw holes of the door panel, and fix the
hanging bracket to the door panel with 8Gx16 mush washer screws (D).
– 6x screws for 18” (457mm)
– 10x screws for 24” (610mm) and 30” (762mm)
D
E
E
5 Align the side panel bracket assembly (bracket, slider and spacer) to the screw holes on the
side of the door panel and fix with 8Gx16 mush washer screws (E).
Attach the top and side hanging brackets to (Stainless steel) door panel
B
2 Remove the top hanging bracket from the
top of the door and set aside (B).
3 Unscrew the adjustment screws by 1/8”
(3mm) to move close to the middle of
adjustment range (C).
A
1/8”
(3mm)
C
1 Remove the M8 washer and M8 nut fromthe M8 screws at the top the door (A).