Joiner Kit Guide

4
6 REMOVING HINGE BRACKET AND FITTING ALCOVE BRACKET
Fitting alcove bracket
4
Screw the front two M5x8 countersunk Phillips screws (refer to C). Check that the top face
of the front trim is parallel to the product.
5
Shift M5x10 pan head Phillips trim attachment screws into the slots in the alcove bracket,
(refer to D).
– If you are not satisfied that the front trim is parallel to the product, screw the jacking
screw supplied: M5x12 Socket head cap screw (refer to E) to adjust the trim position.
6
Once you are satisfied that the front trim is parallel to the product, secure the alcove bracket
with the third countersunk screw (refer to F).
B
A
E
F
C
D
Removing hinge bracket
The following steps show how to remove the hinge bracket (non hinged side) and fit the
alcove bracket. This process is required on both left hinge and right hinge products.
<1/4” (6mm)
Top trim
1
Ensure the distance between the end of the top trim and the side of the cabinet is no
greater than 1/4” (6mm). If distance is greater than 1/4” (6mm), loosen the pan head Phillips
screws at the back of the trim and shift the trim sideways to suit.
2
On the right hand side (when facing the product) loosen the M5 x 10 pan head Phillips top
trim attachment screws. Shift screws towards the center of the trim, (refer to A).
3
Remove the right hinge bracket from the left hinge product by unscrewing the countersunk
Phillips head screws with a Phillips head screwdriver (refer to B).
Repeat process of removing hinge bracket and fitting alcove bracket on the right
hinge product.
We have recommended starting with the left hinge product, then repeating the process on the right hinge product.