Installation Guide

After regulation repeat the operations indicated in paragraph “2. Pressure

regulator” at page 9 and 12.

If the range has been disconnected and then connected again to the gas sup-

ply line repeat the operations indicated in paragraph “5. Leak Testing” at page

12.

IMPORTANT:

After conversion to LP/PROPANE gas has been carried out affix inside the

drawer, near the data plate, the conversion label supplied and also affix a con-

version label at page 3 of this instruction manual.

ADJUSTMENT OF THE OVEN BURNER MINIMUM

This needs to be done only for the oven burner (the broil is a fixed capacity)

by acting on the thermostat in the following way:

– Turn on the burner by setting the thermostat knob on position

– Remove the knob and unscrew the by-pass screw "G" (fig. 2.14) about three

times by passing a small flat screwdriver (Ø 3 mm blade, 100 mm length)

through the panel opening.

– Re-mount the knob and let the oven heat up for about 10 minutes, then bring

the knob to position

1 (minimum) to operate the thermostat by-pass.

– After having removed the knob again and being very careful not to turn the

tap rod, slowly screw the by-pass screws “G” (fig. 2.14) until you obtain a

flame of 3-4 mm in height.

N.B. For LP/PROPANE gas the by-pass screw must be fixed thoroughly.

Fig. 2.14