User's Manual

1. POWER/VOLUME CONTROL: Turns the power on

and off. Also controls the target response volume

in the headphones. The volume control should be

set no louder than comfortable when the search

coil is passed over a large, close target.

2. DISCRIMINATION CONTROL: A full range trash

rejection control. All types of metal are detected

at the zero level and most small pieces of trash

are eliminated at the maximum level of ten.

3. LED: The clear plastic window between the

SENSITIVITY and VOLUME controls contains an LED

(Light Emitting Diode) which flashes red when a

target is detected or the batteries are being

tested.

4. BATTERY TEST/SENSITIVITY CONTROL: Checks

battery condition and controls the sensitivity to

targets. A setting of 10 gives maximum sensitivity

and is used for most treasure hunting conditions.

To check the batteries, turn the VOLUME control

to 10 and click the BATTERY TEST/SENSITIVITY control

momentarily in and out of the “Battery Test”

position. Fully charged batteries will give a loud

tone in the earphones and a bright red light in

the LED window. Weak batteries will give a faint

tone and a dim light. It’s time to replace the

batteries when the light goes out.

CONTROL PANEL

Figure 4. Control Panel