Installation Sheet

Surface Mount Installation
C
reate a cutout
as defined in
the planning guide.
Important: make sure
that the distance
between the shelf
and the bottom edge
of the cutout is as
specified in the
planning guide. (1)
P
lace the runners
in the cabinet and align them with the front edge of
the shelf. Take the microwave and place it on top of the
runners. Center the microwave inside the cabinet opening.
Important: make sure
that the microwave
feet are centered on
the runners. Mark the
position of the runners.
Remove the microwave
and secure the runners
with the supplied
screws. (2)
P
lug in the micro-
wave and place it
on the runners. Center the microwave within the opening.
Temporarily mount the EuroTrim™ and mark the location of
its outside corners with
a non-permanent
marker or pen. Bend
the magnet mounts as
shown and screw them
onto the front of the
panel. Keep about
1/4”-inch (6mm)
distance from the
marked outside cor-
ners. Bend the flaps
of the magnet mount as required to fine-tune the alignment
between the EuroTrim™ and the microwave. Next, open the
microwave door and check for proper clearances. Adjust the
alignment of the EuroTrim™ by removing it briefly and reposi-
tioning the flaps of the magnet mount until you are satisfied. (3)
R
emove the
EuroTrim™
without moving
the microwave.
Peel off the
protective PVC
coating from the
STOPADS©
Careful: They are
very sticky. Gently
hook them behind
the front feet of
the microwave. After initial contact firmly press them onto the
runners. Hint: Lift the microwave up at the front and push it
back far enough to rest the feet temporarily on the STOPADS©.
Next, wiggle the handle of the STOPADS© horizontally until
they break off. Then, pull the microwave toward you until the
feet come to a rest inside the STOPADS©. (4)
L
astly, take the EuroTrim™ and click it into position. If you
are satisfied
with the installa-
tion, remove it
one more time,
peel off the
protective PVC
coating from the
EuroTrim™ and
click it into place
for its final mount.
(5)
The End
5
3
2
1
4
For replacement parts or if further help is needed concerning this appliance call:
Toll Free 1 888 9 FNP USA (1 888 936 7872) or write to:
Fisher & Paykel Appliances Inc., 5900 Skylab Road, Huntington Beach, CA 92647
or contact us through our web site: www.fisherpaykel.com