Installation Guide

@5 OPTIONAL — CHANGING OVER DOOR HINGES

Top hinge installation

1 Reinstall the hinge top bracket and bracket

spacer with M5x12 countersunk screws (A) on

the new hinge side at the other side of the

appliance.

2 Install the new hinge pocket and alcove top

bracket on the new hinge side using two (2x)

M5x12 pan head screws (B).

Note: The new hinge pocket and alcove top

bracket are supplied with the hinge kit.

3 Install the new hinge in the new hinge pocket by

screwing M5x12 pan head screws (2x) (C). (Not

applicable to RS18).

4 Open the hinge and reinstall the top hinge

pocket cover (D) to the top hinge pocket.

5 Install a new alcove top bracket on the new non-

hinge side. (Not applicable to RS18) (E).

Bottom hinge installation

6 Install a new lower hinge bracket on the new

hinge side with M6x16 screws (2x) (F).

– Ensure that the tab on the top of the

bracket inserts into the slot in the plinth

front bracket.

7 Use the hinge that was removed from the top of

the appliance and insert the tabs into the hinge

lower bracket. Rotate the hinge into place and fix

with M5x12 countersunk screws (2x) (G).

8 Open the hinge (H), and install the new top

(fixed) grille assembly.

9 Fasten in place with #8x16 screws (3x) (I). One

each at the bottom left and right of the grille and

one behind the water filter hatch.

Reinstall the bottom hinge pocket cover to the

new hinge pocket (J).

Required components/tools:



Left/right hinge change kit (refer to

‘Components list’)

– 1x Top (fixed) grille assembly

– Hinge change assembly



T20 star screwdriver



Flat head screwdriver