Installation Guide

41
@5 OPTIONAL — CHANGING OVER DOOR HINGES
Removing the top door hinge
1 Rotate the top hinge (A) outwards and remove
the top hinge pocket cover (B) using the flat
head screwdriver in the slot of the cover.
2 Remove the hinge by unscrewing the M5x12
pan head screws (2x) (C), and set aside for
later use.
3 Remove the hinge pocket and top alcove
bracket by unscrewing M5x12 pan head screws
(2x) (D) from the hinge pocket.
4 Remove the top hinge bracket and spacer (E)
by unscrewing the M5x12 countersunk screws
(2x) from the top hinge bracket.
5 For the non-hinge side, remove the top alcove
bracket by unscrewing the M5x12 pan head
screws (2x) (F). (Not applicable for RS18).
Removing the bottom door hinge
6 Rotate the bottom hinge (G) outwards and
remove bottom hinge pocket cover (H) using a
flat head screwdriver in theslot.
7 Remove the hinge by unscrewing the M6x16
countersunk screws (2x) (I).
8 Open the water filter hatch on the bottom
(fixed) grille and unscrew the #8x16 screw (J)
while holding the grille in place.
9 Remove the bottom grille by unscrewing the
#8x16 screws (K) from the bottom left and
right of the grille.
!0
Remove bottom hinge bracket by unscrewing
M6x16 countersunk screws (L).
IMPORTANT!
Do not remove plinth-to-cabinet retention
brackets!
Required components/tools:

T20 star screwdriver

Flat head screwdriver
A
G
E
C
D
F
J
L
B
K
I
K
H
Do not remove!
Do not remove!