Quick Start Guide

USING THE TIMER
FOR MORE INFORMATION
REPOSITIONING THE SHELVES
For detailed information on the
features of your oven
For warranty information
If you…
●
have any questions or comments
●
need a Fisher & Paykel authorized
technician to service your product
●
need replacement parts or accessories
●
want to register your product
see your ‘User guide’
see your ‘Service and warranty’ booklet
see your ‘Service and warranty’ booklet or contact us
USA toll-free, 24/7 1 888 936 7872
CA toll-free, 24/7 1 888 936 7872
www.fisherpaykel.com
Placing the telescopic sliding shelves on the side racks provides EIGHT cooking
positions to choose from. Refer to the User guide for suggested shelf positions.
Note: generally, the shelf positions in the top of the oven are suitable for broiling.
Those in the middle or lower region of the oven are suitable for baking, roasting and casseroles.
●
Always position oven shelves BEFORE heating the oven.
●
To remove a sliding shelf, grip it by its two front corners (making sure you are gripping the wire shelf
and the sliding frame together), tilt upwards and pull it out of the oven.
●
To place a sliding shelf in the oven correctly, position it so that the front bar is toward you, as shown.
●
Check that the sliding frame is not extended.
●
Check the guard rail (as shown) to make sure the shelf is the right way up.
●
Position the shelf so that it is level and the rear shelf tags on both sides of the sliding frame rest on the
side racks (as shown).
●
Then push the sliding shelf all the way to the back of the oven, until the front shelf tags drop into
place.
●
For your safety, the wire shelves and telescopic sliding frames are built together as one unit and are
not separable. This means that when placed properly on the side racks, the slides will prevent the wire
shelves from tilting when pulled towards you.
●
To prevent the tags from lifting off the side racks, take care to slide the shelves forward horizontally.
Shelf positions
1
2
3
4
5
6
7
8
Side rack
Side rack
Mounting
slots
Retaining wire
Lock
stud
Wire shelf
Front bar
Sliding frame
(push fully into place)
Shelf tag
Guard rail
1 Select the timer by pressing
the right scroll button once.
●
The timer indicator will
appear and the colon will
flash.
2 Press the select
button to
confirm.
●
The display will flash to
indicate the timer is ready
to be set.
3 Set the time by pressing
the scroll buttons.
●
Holding the buttons
down will speed up the
scrolling.
4 Press the select button
to confirm.
●
The timer will then begin
to count down.
●
If you want to check the
time of day, press the
cancel button once.
●
Press the right scroll
button to scroll back to
the timer.
●
You can use the timer at any time, even if you are not using the oven.
●
If the time is more than an hour, the display will count down in minutes (hr:min). If it is less than an hour, it will count down in seconds
(min:sec).
●
You can set the timer for up to 23 hours 59 minutes.
IMPORTANT!
The timer does NOT turn the oven off.
To modify the timer setting
1 Make sure the display shows the remaining time counting down.
2 Press the select button.
3 Press the scroll buttons to set a new time.
4 Press the select button to confirm.
To cancel the timer setting
1 Make sure the display shows the remaining time counting down.
2 Press the cancel button until the display shows the time of day and the timer indicator disappears.
When the set time is up
●
The display will show 0:00 and a tone will sound every 15 seconds.
●
Press any button to stop the tone sounding. The display will revert to showing the time of day.
590699 B 08.17