Installation Guide

ManualsBrandsFisher and Paykel ManualsDishwashersFisher and Paykel DishDrawer 24 Inch Wide 14 Place Setting Energy Star Rated Built-In Fully Integrated Dishwasher with Built-In Water Softener and Recessed Handle

10

!1-A SECURE TO THE CABINETRY ON THE SIDES !2-A OPTIONALLY SECURE TO THE CABINETRY ABOVE

2

1

3

Open the drawer

halfway. Using

a flat bladed

screwdriver, prise

the gray rubber

plug out of the

trim moulding.

Replace the gray

rubber plug back into

the trim moulding

and ensure the trim

seal is facing forward.

Repeat for all

four brackets.

Using a small Philips

screwdriver, screw

through the trim

moulding, securing the

side mounting bracket

to the cabinetry.

Do not damage the

rubber trimseal.

(x2)

The top mounting

brackets will only

bend upwards a

maximum of 3/8”

(10 mm).

!3-A FIT THE SUPPLIED TOEKICK PANEL

19

1

3

5

7

8

9

2

6

4

19

IMPORTANT!

Do not overtighten screw.

Where the toekick

meets the bottom

of the tub is the

cut-off point

Mark this point on the

toekick with a pencil

Lay the toekick face down on

a chopping board or similiar

Smooth the edge with a file.

Be careful of sharp edges.

Snap off the two end tabs

Slide the toekick onto

the mounting rails

either side and screw

the toekick onto the

bottom of tub on

either side.

Mounting rail

Score along the marked

cutoff line with a knife

Turn the toekick over and

score along the same line

Gently snap off the excess