Datasheet

h
ef, max
30 mm
h
ef, min
30 mm
1
2
1
2
ETA-05/0069
ETAG 001
Option 1 for cracked concrete
seismic performance category C1, C2
(only FAZ II C)
S
E
I
S
M
I
C
Your advantages at a glance
NEW
NEW
NEW
Variable
The interaction of cone and expansion clip significantly
increases load-bearing capacity and makes minimum
edge distance and axial spacing possible.
The protruding hammer-in pin
protects the thread from damage
during setting.
The distinctive edge holds the
expansion clip in position even
with reinforcement hits, thus
ensuring
safe installation.
With a choice of pre-assembled normal washer
or large washer GS
and with washer HBS in
compliance with wood construction standard
DIN 1052 (not pre-assembled).
Powerful and flexible
Maximum load with maximum embedment depth FAZ II 10 A4
60 mm embedment depth = maximum permissible tension load of
6.2kN and shear load of 15.1 kN.
Permissible loads may be calculated for embedment depth between
40 mm and 60 mm.
Fast installation thanks to minimum embedment depth FAZ II 10 A4
40mm embedment depth = permissible tension load of 4.3 kN and shear
load of 11.3 kN.
Variable embedment depths
Enables most accurate adaption on the loads (M 8 - M 16).
Approvals
Bolt anchor FAZ II
For highest demands
Powerful and flexible
The eight new sizes of the special cap
nut version (M10 and M12) can be
used for the application on
sophisticated design . They are also
implemented in the ETA assessment.
■ With the new ETA assessment for Option 1 the tension loads are
increased up to 10% and the shear loads up to 17%. So fewer
and smaller anchors are required.
■ The minimum embedment depth (see example) makes
considerably shorter drill hole depths possible, thus provides a
noticeably faster installation and less rebar hits.
■ The new cup nut, not only gives the option for a better and
refined optical design but also, ensures an accident free
installation.
■ FAZ II 6: First bolt anchor with drill-hole diameter 6 mm and ETA
Option 1 worldwide, for safe and approved anchorage.
■ The FAZII is suitable for pre-positioned and push-through
installation and is also ideal for stand-off installation.
■ Experts report for use in concrete C12/15 and C80/95.
■ The assessment document covers the use of hollow drills and
diamond drills.