Owner's Manual

Page 5For technical questions, please call 1-888-866-5797.Item 63298
SAFETYOPERATIONMAINTENANCE ASSEMBLY SAFETYOPERATIONMAINTENANCE ASSEMBLY
4. Insert Cross Beam (33) through the bracket on the Upper Lift Arm Assembly as shown and align bolt holes.
Insert Cross Beam Pin (36) through center of bracket and Cross Beam.
Secure Cross Beam Pin in place with R-Clip (23).
Upper Lift
Arm Assembly
Cross Beam Pin (36)
Cross Beam (33)
R-Clip (23)
Step 4: Attach Cross Beam
5. Slide one Wheel Bracket (34) over each end of the Cross Beam (33).
Insert Width Pins (31) to secure them in place.
Remove the R-Clip (23) and Flat Washer (29) from one end of each Wheel Bracket Rod (32).
Insert one Wheel Bracket Rod through the holes on each Wheel Bracket.
Replace the R-Clip and Flat Washer on the end of each Wheel Bracket Rod to secure the Rods in place.
Width Pin (31)
Wheel Bracket (34)
Cross Beam (33)
Wheel
Bracket
Rod (32)
Flat
Washer
(29)
R-Clip
(23)
Step 5: Install Wheel Brackets and Attach Wheel Bracket Rods