Owner's Manual

Page 4 For technical questions, please call 1-888-866-5797. Item 63298

SAFETY OPERATION MAINTENANCEASSEMBLY

3. Remove the R-Clip (23) and Flat Washer (8) from one end of the Short Lift Arm Rod (25).

Remove the Cotter Pin (12) and Flat Washer (8) from one end of the Long Lift Arm Rod (24).

Place the Lower Lift Arm (21) in position, then insert the Short Lift Arm Rod through the

bracket on the Upper Lift Arm Assembly (26) and the front end of the Lower Lift Arm.

Replace the Washer over the end of the Short Lift Arm Rod and use an R-Clip to secure the Rod in place.

Raise up the previously installed Support Bars. Insert the Long Lift Arm Rod through the Support Bar, the

shaft of the Upper Lift Arm Assembly, the rear end of the Lower Lift Arm, and the other Support Bar.

Replace the Washer over the end of the Long Lift Arm Rod and insert the

Cotter Pin and bend it over to secure the Rod in place.

Lower Lift Lower Lift

Arm (21)Arm (21)

Upper Lift Arm Upper Lift Arm

Assembly ShaftAssembly Shaft

Short Lift Arm Rod (25)Short Lift Arm Rod (25)

Long Lift Arm Rod (24)Long Lift Arm Rod (24)

Support Support

Bar (11)Bar (11)

Cotter Cotter

Pin (12)Pin (12)

R-Clip R-Clip

(23)(23)

Washer

(8)

Washer (8)Washer (8)

Lower Lift Arm Lower Lift Arm

in placein place

Support Bar Support Bar

in placein place

Short Lift Arm Rod Short Lift Arm Rod

attachmentattachment

Long Lift Arm Rod Long Lift Arm Rod

attachmentattachment

Upper Lift Arm Upper Lift Arm

AssemblyAssembly

Step 3: Attach Lower Lift Arm to Upper Lift Arm Assembly and Support Bars