Owner's Manual

Page 3For technical questions, please call 1-888-866-5797.Item 63298

SAFETYOPERATIONMAINTENANCE ASSEMBLY

Assembly Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document

including all text under subheadings therein before set up or use of this product.

1. Place the Base (2) flat on a horizontal surface.

Place the Upper Lift Arm Assembly onto the end of the Base

as shown and align the bolt holes.

Secure the Upper Lift Arm Assembly to the Base using two Bolts (6),

Flat Washers (8), Lock Washers (9), and Nuts (10).

Bolt (6)

Nut (10)

Lock Lock

Washer Washer

(9)(9)

Flat Flat

Washer Washer

(8)(8)

Upper Upper

Lift Arm Lift Arm

AssemblyAssembly

Base Base

(2)(2)

Step 1: Attach Upper Lift Arm Assembly to Base

2. Place the two Support Bars (11) as shown and align with the bolt holes in

the Base. Note that flat sides of Bars must align against Base as shown.

Attach the Support Bars to the Base using one Bolt (7),

Flat Washer (8), Lock Washer (9), and Nut (10) per bar.

Finger tighten the hardware.

Bolt (7)

Nut (10)

Lock Lock

Washer (9)Washer (9)

Flat Flat

Washer Washer

(8)(8)

Support Support

Bar Bar

(11)(11)

Base Base

(2)(2)

Step 2: Attach Support Bars to Base