User's Guide
Table Of Contents
- 1. Charging
- 2. Using the Firstbeat Bodyguard 3 for the first time
- 3. Pairing Firstbeat Bodyguard 3 with a Firstbeat Life account
- 4. Switching the user Firstbeat Bodyguard 3 user
- 5. How to make a measurement
- 6. Signal light explanations
- 7. Technical Information
- 8. Disposal of the Firstbeat Bodyguard 3
- 9. Certification Statements
- 10. Safety Information
- 11. Contact Information
9
FCC Requirements for Operation in the United States
FCC Information to User
This product does not contain any user serviceable components and is to be used with approved,
internal antennas only. Any product changes or modifications will invalidate all applicable regulatory
certifications and approvals.
FCC Guidelines for Human Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Federal Communications Commission Statement
This device complies with Part 15 Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause
undesired operation.
FCC Radio Frequency Interference Warnings & Instructions
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following methods:
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an electrical outlet on a circuit different from that which the
radio receiver is connected
• Consult the dealer or and experienced radio/TV technician for help
FCC Caution
• Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
• This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference, and
2) this device must accept any interference received, including interference that
may cause undesired operation.