User Manual

SlateVision System User Guide
14
Preparing the Power Supply
SlateVision features a two-way power supply that lets you use either batteries or a
household AC current.
Using Battery
The primary source of SlateVision power is a battery pack. The 6-cell 3600 mAH
Lithium-Ion battery combined with the Code Morphing Software advantage of the
Crusoe processor allows up to 3 - 5 hours of battery life at full on operation (with www
access).
The battery pack is visible and accessible from rear of SlateVision. Recharging is
available using the AC-DC adapter provided with SlateVision. It is not necessary to
access the battery pack except to replace a fresh battery pack.
To remove the battery pack, follow these steps:
 Turn off SlateVision power.
 Slide the latch from right to left orientation as shown in [Figure. 2.1.1] and
[Figure. 2.1.2] below. Slide the latch first, and then slide the battery from left to
right orientation as shown in [Figure. 2.1.1] and [Figure. 2.1.2] below.
 Remove the discharged batteries and replace with new Lithium battery.
 Turn on SlateVision power.
Figure 2.1.1 Battery pack replacement battery