User Manual

SlateVision System User Guide
58
2. Set up speakers
 You can plug an external speaker into the Line-out jack or using the
external speaker.
 Open Speech in Control Panel.
 On the Text-to-Speech tab, click Preview Voice to hear the currently
selected voice; the text will be spoken, highlighting the words as they are
spoken. If the speakers are working properly, you will hear the spoken
words.
3. Change languages
The language used by either speech recognition (SR) or text-to-speech (TTS) is
dependent on the respective engine. Only one engine of each type (SR and TTS)
can be active at a given time. You may decide a particular engine better meets
your requirements and use that engine more often. Once an engine is set, it is not
usually necessary to change it.
To change an SR language:
 Open
Speech
in
Control Panel.
 On the Speech Recognition tab, change the SR language by changing
the SR engine.
To change a TTS language:
 Open Speech in Control Panel.
 On the
Text-to-Speech
tab, change the TTS language by changing the
TTS engine.