User's Manual

Convertible Tablet PC
3
United
UL
2
• Flexible cord must be <HAR> Type HO5VV-F, 3-conductor. 1.0 mm2
conductor size. Power cord set fittings (appliance coupler and wall plug)
must bear the certification mark of the agency responsible for evaluation in
the country where it will be used.
• Flexible cord must be Type SVT or equivalent. No. 18 AWG, 3-conductor.
Wall plug must be a two-pole grounding type with a NEMA 5-15P (10A.
125V) or NEMA 6-15P (15A 250V) configuration.
• Appliance coupler, flexible cord, and wall plug must bear a “T” mark and
registration number in accordance with the Japanese Dentori Law. Flexible
cord must be Type VCT or VCTF, 3-conductor, 0.75mm2 conductor size.
Wall plug must be a two-pole grounding type with a Japanese Industrial
Standard C8303 (15A, 125V) configuration.
General Requirements
The requirements listed below are applicable to all countries:
• The length of the power cord set must be at least
6.0 feet (1.8 m) and a maximum of 14.76 feet (4.5 m).
• All power cord sets must be approved by an
acceptable accredited agency responsible for evaluation in the country
where the power cord set will be used.
• The power cord set must have a minimum current
capacity of 10A and a normal voltage rating of 125 or 250 volts AC, as
required by each country’s power system.
• The appliance coupler must meet the mechanical
configuration of an EN 60320. / IEC 320 Standard Sheet C13 connector,
for mating the appliance inlet on this Convertible Tablet PC.