User's Manual

3-8 Using the BIOS Setup Utility
! BootUp Message — Enabled allows a boot message to be displayed while the
system boots.
! Save to Disk Warning — When set to Disabled, no Save-to-Disk warning is
displayed if the SAVE2DSK.BIN file does not exist.
! Summary Screen — When set to Enabled, system configuration information is
displayed on the screen during boot.
! Silent Boot — When set to Enabled, the NEC logo screen is displayed during
system boot. When set to Disabled, the Power-On Self-Test (POST) information is
displayed during system boot. When set to Black, the screen is black until the
system has booted.
! Wireless Device — Enabled allows a Wireless LAN device (if installed) to be used.
Disabled prevents a wireless device from functioning. (This setting only appears on
systems with a Wireless LAN device installed.)
! I/O Device Configuration — Pressing the Enter key brings up a sub-menu with
entries for enabling the serial port, infrared port, parallel port, and the diskette drive
controller. The infrared (IR) port is disabled by default. See “IR Port” in Chapter 6
for information about using the IR port.