User's Manual

Notebook User Guide

already installed all the drivers along with the operating system. If not, follow the

procedures below:

INSTALLING WINDOWS XP FROM CD/ DVD/ CD-

RW/ C

OMBO DRIVE

To install Windows XP directly from your CD-ROM or DVD-ROM, please go

to Boot menu of BIOS setup menu. Use arrow key to select "CD-ROM Drive",

then use "+ " or "-" to move it to the top. Go to E xit menu and select " E xit

Saving Changes" . Accordingly, insert the Windows XP installation CD into

CD-ROM drive with following the instructions on the screen to finish the

installation.

E NABLE DMA CHANNE L FOR BE ST PE RFORMANCE

This Notebook supports DMA function for fastest data bus transmission. The

Windows system does not enable this function after you had installed the

Windows system. You must enable this function manually to make this

notebook running smoothly, especially in music listening and DVD, VCD

playback.

E nable DMA for Windows XP

1. Please click the following buttons with the procedure Start --> Setting-->

Control Panel --> System --> Hardware --> Device Manager.

2. Select and click IDE ATA/ ATAPI Controller, you will find Primary IDE

Channel and Secondary IDE channel. Please click Primary IDE Channel

first.

3. Click Advanced setting Tab. Please change the selection of Transfer Mode

to DMA if available on both Device 0 and Device 1.