User's Manual

Getting Started 2

After the test, the screen will also display a message "press <F2> to enter

SE TUP". You don’ t need to run this program at the moment as your dealer

already made the necessary settings for your computer optimal operation. Refer to

Chapter 6 on running the SE TUP program later.

After the test has completed, your computer will start to search and boot up the

operating system from your hard drive. The notebook computer normally comes

with a Windows operating system pre-installed in your hard drive. Consult the

Windows manual on how to use the program. If not, contact your dealer for

assistance.

2.5 Adjusting the Display Controls

The LCD brightness adjustment is controlled by < Fn> + < F8 > and < Fn> +

<F9> keys respectively. You need to press these hot-key controls after powering

on your notebook to suit your viewing pleasure.

The Brightness hot-key control adjusts the brightness on the LCD. The

brightness hot-key control will not set the LCD completely dark or bright; it

provides sufficient lighting to the LCD to match the external lighting of the

surrounding. The brighter the room, the more you need to increase the

brightness of the LCD.

2.6 Installing the Notebook Device

Drivers

If you already have an operating system installed into your notebook computer, it

is best to install the needed device drivers for using the built-in devices of your

computer. Before installing the drivers, check with your dealer first if they have