User's Manual
Table Of Contents
- Trademarks
- Safety and Care Instructions
- About Your Mini-note
- About Your User Guide
- 1 Introduction
- 2 Getting Started
- 2.1 Using the Battery Pack
- 2.2 Connecting the AC Power Source
- 2.3 Starting Your Mini-note
- 2.4 Adjusting the Display Controls
- 2.5 Device Drivers Installation
- Installing Windows XP from Optical Disk Drive
- Installing the Chipset Driver
- Installing the VGA Device Driver
- Installing the Audio Device Driver
- Installing the Glide Pad Device Driver
- Installing the Wireless LAN Device Driver
- Installing Bluetooth Device Driver
- Installing the LAN Device Driver
- Installing the Care Reader Device Driver
- 2.6 Turning off Your Mini-note
- 3 Using Your Mini-note
- 4 Fun with Multimedia
- 5 Connecting to Peripherals
- 6 Customizing Your Mini-note
- _
- 7 Using Options
- 8 Caring for Your Mini-note
- APPENDIX A System Specification
User Guide
System Upgrade
This section provides some steps in doing system upgrade for your Mini-note.
The upgrade procedures include the following:
7.1 Hard Disk Upgrade
Your notebook computer offers one 1.8" format, 8 mm height hard disk. If the
volume does not fit your need or it is crashed, you can upgrade it by replacing
with new hard disk. Please do the following steps to change it.
1. Remove the screw and open the cover by lifting its upper side cover.
2. Take out the hard disk from the compartment by finger carefully
3. Remove the connector from the hard disk gently.
4. Remove the crane screws located at each side of the hard disk.
5. Rotate and tighten the crane screws to the new hard disk.
6. Attach the connector to the new hard disk precisely.
7. Place the hard disk back to the compartment.
90