User's Manual
Table Of Contents
- Trademarks
- Safety and Care Instructions
- About Your Mini-note
- About Your User Guide
- 1 Introduction
- 2 Getting Started
- 2.1 Using the Battery Pack
- 2.2 Connecting the AC Power Source
- 2.3 Starting Your Mini-note
- 2.4 Adjusting the Display Controls
- 2.5 Device Drivers Installation
- Installing Windows XP from Optical Disk Drive
- Installing the Chipset Driver
- Installing the VGA Device Driver
- Installing the Audio Device Driver
- Installing the Glide Pad Device Driver
- Installing the Wireless LAN Device Driver
- Installing Bluetooth Device Driver
- Installing the LAN Device Driver
- Installing the Care Reader Device Driver
- 2.6 Turning off Your Mini-note
- 3 Using Your Mini-note
- 4 Fun with Multimedia
- 5 Connecting to Peripherals
- 6 Customizing Your Mini-note
- _
- 7 Using Options
- 8 Caring for Your Mini-note
- APPENDIX A System Specification
User Guide
88
• Save Changes
Saves Setup data to CMOS.
6.7 How to Upgrade the BIOS
Your Mini-note uses EPROM Flash BIOS chip that allows you to easily
upgrade the BIOS program. When you update the BIOS, any customized
settings you made are lost.
To upgrade the BIOS:
1. Put in the BIOS Update data into the USB device.
2. Power on the system with the diskette in the diskette drive.
3. On the DOS prompt, type the following command.
A:\>Phlash XXXXXX.ROM (BIOS filename) or
A:\>XXXXXX.BAT (Batch file for BIOS file)
Press <Enter> to run this BIOS utility. After the system has been
successfully run this program, a message similar to the following appears:
Flash memory has been successfully programmed,
press any key to restart the system. If the
system does not restart, turn it off, then turn
on again.
4. Press any key to restart this system.
Contact your dealer for the latest BIOS update file.