User's Manual
Table Of Contents
- Trademarks
- Safety and Care Instructions
- About Your Mini-note
- About Your User Guide
- 1 Introduction
- 2 Getting Started
- 2.1 Using the Battery Pack
- 2.2 Connecting the AC Power Source
- 2.3 Starting Your Mini-note
- 2.4 Adjusting the Display Controls
- 2.5 Device Drivers Installation
- Installing Windows XP from Optical Disk Drive
- Installing the Chipset Driver
- Installing the VGA Device Driver
- Installing the Audio Device Driver
- Installing the Glide Pad Device Driver
- Installing the Wireless LAN Device Driver
- Installing Bluetooth Device Driver
- Installing the LAN Device Driver
- Installing the Care Reader Device Driver
- 2.6 Turning off Your Mini-note
- 3 Using Your Mini-note
- 4 Fun with Multimedia
- 5 Connecting to Peripherals
- 6 Customizing Your Mini-note
- _
- 7 Using Options
- 8 Caring for Your Mini-note
- APPENDIX A System Specification
Connecting to Peripherals 5
network (LAN) and supports data transfer rates at 10Mbps and can be up to
100Mbps. The 10Base-T standard also called Twisted Pair Ethernet is
connected with RJ-45 connectors. The 100Base-TX is based on the older
Ethernet standard. Because it is 10 times faster than Ethernet, it is often
referred to as Fast Ethernet.
The built-in LAN module provides a standard RJ-45 connector.
To connect the twisted-pair cable to your LAN port:
1. Locate the twisted-pair cable in the accessories box in Mini-note shipping
carton. Each end of the cable has a RJ-45 connector.
2. Connect one end of the cable into the network wall outlet or HUB.
3. Connect the other end of the cable into the Mini-note RJ-45 LAN port.
5.5 Using the Wireless LAN
Wireless LAN lets user connect to the LAN environment without using any
wire to traditional RJ-45 jack. User can enjoy the wireless connection within
the range of Access Point (AP) of LAN.
75