User's Manual
Table Of Contents
- Trademarks
- Safety and Care Instructions
- About Your Mini-note
- About Your User Guide
- 1 Introduction
- 2 Getting Started
- 2.1 Using the Battery Pack
- 2.2 Connecting the AC Power Source
- 2.3 Starting Your Mini-note
- 2.4 Adjusting the Display Controls
- 2.5 Device Drivers Installation
- Installing Windows XP from Optical Disk Drive
- Installing the Chipset Driver
- Installing the VGA Device Driver
- Installing the Audio Device Driver
- Installing the Glide Pad Device Driver
- Installing the Wireless LAN Device Driver
- Installing Bluetooth Device Driver
- Installing the LAN Device Driver
- Installing the Care Reader Device Driver
- 2.6 Turning off Your Mini-note
- 3 Using Your Mini-note
- 4 Fun with Multimedia
- 5 Connecting to Peripherals
- 6 Customizing Your Mini-note
- _
- 7 Using Options
- 8 Caring for Your Mini-note
- APPENDIX A System Specification
User Guide
Refer to Chapter 3 regarding the possible External CRT resolutions and
how to change the display properties.
5.3 Using the External Audio System
At the front side of your Mini-note, you will find the built-in audio ports. You
can connect Microphone jacks, earphone or powered speaker.
To connect to an audio jack:
1. Locate the audio port (Microphone, Headphone) that you want to use to
the target device.
2. Plug the jack into the port on the front side of the system.
If you use external speaker and experience the sound distortion or
feedback, please lower the volume. Some factors is caused by too close
locating the microphone and speaker from each other, moving away the
external audio option from the unit may also help.
5.4 Using the LAN Port
This Mini-note comes with an internal 10Base-T/100Base-TX LAN module
that connects your Mini-note to other notebook/networks through a local area
74