User's Manual
Table Of Contents
- Trademarks
- Safety and Care Instructions
- About Your Mini-note
- About Your User Guide
- 1 Introduction
- 2 Getting Started
- 2.1 Using the Battery Pack
- 2.2 Connecting the AC Power Source
- 2.3 Starting Your Mini-note
- 2.4 Adjusting the Display Controls
- 2.5 Device Drivers Installation
- Installing Windows XP from Optical Disk Drive
- Installing the Chipset Driver
- Installing the VGA Device Driver
- Installing the Audio Device Driver
- Installing the Glide Pad Device Driver
- Installing the Wireless LAN Device Driver
- Installing Bluetooth Device Driver
- Installing the LAN Device Driver
- Installing the Care Reader Device Driver
- 2.6 Turning off Your Mini-note
- 3 Using Your Mini-note
- 4 Fun with Multimedia
- 5 Connecting to Peripherals
- 6 Customizing Your Mini-note
- _
- 7 Using Options
- 8 Caring for Your Mini-note
- APPENDIX A System Specification
User Guide
58
Shutdown
All power has been turned off from the Mini-note. This means that no power
including external AC power source and battery power source will be consume
by the Mini-note.
3.6 Working with the Built-in HDD
Your Mini-note is equipped with a built-in large capacity 1.8 inch hard disk
drive where you store and run your Mini-note’s operating system and
application software programs.
3.7 Using Flash Memory Cards
FLASH MEMORY CARD
Flash Memory is a memory storage media. It is used by most digital camera,
Flash memory card is built with different form factor and brand name. The 4
in 1 card slot in this Mini-note supports following cards as SD, MS (Memory
Stick), MMC, and MS_Pro.
For a single moment, only one card can be inserted into the 4 in 1 card slot.
Inserting Flash Memory Card
To insert a flash memory card into the slot, please pay more attention
whenever insert the flash memory card into the slot with the correct side.
You should position the copper connector at the bottom side. All of these
cards should be located at the center of the slots in inserting.