User's Manual

UMPC User Guide
70
3. Connect the monitor power cable and plug it into a properly grounded
wall outlet.
4. Turn on the power of the monitor.
5. Turn on your UMPC. Both the LCD panel and the monitor screen will
show the display. Your computer is set at default to run at simultaneous
display mode.
6. If you only want to show the display on the external monitor and shut off
the LCD display, you can use the <Fn> + <F3> hot-key to switch
display type between LCD and external monitor. Keep pressing the hot-
key until you get the display to external monitor only.
+
Refer to Chapter 3 regarding the possible External CRT resolutions and
how to change the display properties.
5.3 Using the External Audio System
At the right side of your UMPC, you will find the built-in audio ports. You can
connect Microphone jacks, earphone or powered speaker.
To connect to an audio jack: