User's Manual

Getting Started 2

already made the necessary settings for your UMPC optimal operation. Refer

to Chapter 6 on running the SETUP program later.

After the test has completed, your UMPC will start to search and boot up the

operating system from your hard drive. The UMPC normally comes with a

Windows operating system pre-installed in your hard drive. Consult the

Windows manual on how to use the program. If not, contact your dealer for

assistance.

2.4 Adjusting the Display Controls

The LCD brightness adjustment is controlled by <Fn> +<F8> and <Fn> +

<F9> keys respectively. You need to press these hot-key controls after

powering on your UMPC to suit your viewing pleasure.

The Brightness hot-key control adjusts the brightness on the LCD. The

brightness hot-key control will not set the LCD completely dark or bright; it

provides sufficient lighting to the LCD to match the external lighting of the

surrounding. The brighter the room, the more you need to increase the

brightness of the LCD.

2.5 Device Drivers Installation

If you already have an operating system installed into your UMPC, it is best to

install the needed device drivers for using the built-in devices of your UMPC.

Before installing the drivers, check with your dealer first if they have already

installed all the drivers along with the operating system. If not, follow the

procedures below: