User's Manual
UMPC User Guide
32
+
y For the power supply of this equipment, an approved power cord has to
be used.
y Make sure the socket and any extension cord(s) you use can support
the total current load of all the connected devices.
y Before cleaning the UMPC, make sure it is disconnected from any
external power supplies (i.e. AC adapter).
2.3 Starting Your UMPC
The Power/Resume button is found on the right-top of the base unit. Press
the Power/Resume button to start your UMPC and check that if the Power
LED turns on.
After a few seconds, the UMPC’s display will turn on and your UMPC will
begin to execute the Power On Self Test or POST to check if all system
components are running properly. Any error found during the test will be
displayed on the screen and may generate short beep sound as well.
After the test, the screen will also display a message "press <F2> to enter
SETUP". You don’t need to run this program at the moment as your dealer