Installation Guide

Catalog No. FAP130-2039-02 Printed U.S.A Form Disconnect Switch Kit 8/23/2011 pg. 4
Step 4 — Remove knockout “#1” from both sides of “Switch” junction box as shown in figure 5.
Figure 5 – Switch Junction Box Knockout #1
Step 5 — Insert “Switch” junction box in subbase hole “B”. Then insert “Receptacle” junction box in subbase hole
“A” with knockout hole facing “Switch” junction box as shown in figure 6. Use factory supplied screws to fasten
the “Receptacle” and Switch” junction boxes to the subbase.
Figure 6 – Junction Boxes Installed
Step 6 — Insert interconnecting conduit nipple into “Receptacle” junction box knockout hole “#1” and “Switch”
junction box knockout hole “#1”, as shown in figure 7. Then start conduit nuts on each side of the interconnecting
conduit nipple.
Figure 7 - Insert Interconnecting Conduit Nipple
Step 7 — Tighten Conduit nuts inside Switch and Receptacle junction boxes until interconnecting conduit nipple is
secured in place as shown in figure 8.
Figure 8 - Tighten Conduit Nuts