Use and Care Manual

RESET
BUTTON
FS
200m
-7-
USING THE PROJECTOR
Rotate the projector to project the time onto a dark wall or ceiling within 2.3 – 6.6 feet (0.7 - 2 meters) away
from the projector, the projected time will be displayed on the wall or ceiling in the following format.
1. The projector stays on when the main unit is powered by the AC adaptor.
2. The projector will be off when the main unit is powered by batteries. Pressing the SNOOZE/LIGHT
button will momentarily turn on the display back light and the projection for 7 seconds.
3. Rotate the Projector angle to adjust where the time is projected.
4. Adjust the FOCUS control knob of projector to sharpen the projected time.
NOTE: The projector can be rotated ±90º.
CARE AND MAINTENANCE
1. Do not subject the unit to excessive force, shock, dust or extreme temperature.
2. Do not tamper the internal components of the unit.
3. Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.
4. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
5. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or
motors.
CAUTION: Never allow any water or other liquids to get inside the unit while cleaning.
Resetting the Unit
If the unit experiences a power surge or electric shock, it is possible that the internal
micro-controller may lock up and the unit will not respond to any commands from the back panel controls. In
this event, use a straightened paper clip, toothpick or similar objects to press the RESET button located on
the back of the unit (see the below figure). The reset operation clears the system memory and all of your
previous settings will be erased.
CAUTION: DO NOT USE A SHARP OR POINTED OBJECT TO PRESS THE RESET
BUTTON. IT MAY DAMAGE THE RESET SWITCH INSIDE THE UNIT.