User's Manual

65
moISture - We recommend that you place delicate items such as pictures or
intricate jewelry into an air-tight container before storing them in your safe. Avoid
placing your safe in areas of high humidity. For optimum performance, the safe
should be opened and aired out for at least 20 minutes every two weeks.
For future reference, store this Operation and Installation Guide in a secure area away
from the safe. DO NOT DISCARD!
addItIonal FeatureS
SHELVES
To allow for greater exibility and further accommodate your particular storage
needs, this safe includes two (2) adjustable/removable shelves and one (1) gun rack.
to InStall:
1
Remove shelves, gun rack and
12 shelf support clips from
protective wrapping.
2
Each shelf will require four (4)
support clips.
3
Determine the desired location of
your shelf and/or gun rack and note
the corresponding support guide
slots on the vertical standards that
are best suited to support the shelf
in that location.
4
Insert one (1) support clip into each of
the vertical standards. The top of the
support clip should be placed into the
selected slot rst and then the bottom of
clip will lock in place when pushed back.
IMPORTANT
Make sure all four (4) clips are installed at the same height on the vertical
standards so that the shelf is level.
5
Install the shelf into position by placing inside the safe (tilting if necessary) and
lowering into position on the support clips.
6
Repeat procedure for the second shelf.
hInt: If shelves are not being used, they can be stored in the bottom of the safe.
MOUNTING HARDWARE KIT
Many customers prefer to bolt their safe to the wall or oor to increase protection
from theft and resistance to tipping. This safe was manufactured with mounting
holes pre-drilled in the back panel and oor panel. To secure your safe to the wall
and/or oor:
1
Remove the protective liner from the back and/or oor of the safe and locate the
pre-drilled 5/8 in. holes. Using a drill with a 5/8” bit, drill holes into the wall or
oor.
2
Anchor the safe using the mounting hardware kit which includes two (2) 3 x 3/8
in. lag screws and anchors. Securing back of safe to wall studs is important.
3
Once completed, replace protective liners.
IMPORTANT
If you have questions regarding how to permanently secure the safe or are
uncomfortable using the tools necessary to complete the project, please check
with your local retailer, home center or independent contractor. This safe is
heavy and care should be exercised to prevent damage to safe or mounting
surface and/or bodily injury.
conSumer aFFaIrS
YOUR SAFE’S UNIQUE IDENTIFICATION NUMBERS
When contacting Consumer Aairs, you should be prepared to supply some
important information that specically identies your safe. This information is
extremely important to assuring prompt and accurate customer assistance.
It is strongly recommended that you identify and record the following information in
the Safe Identication Record form located on the inside back cover of this manual:
MODEL NUMBER SERIAL NUMBER KEY NUMBER
LOCATING MODEL AND SERIAL NUMBERS
Most First Alert® safes include a small metallic silver or gray tag axed to one of
the surfaces. This tag is usually located on the front or right side of the safe. This
tag contains the serial number, and on selected models a similar tag is attached
containing the model number. If a model number tag is not attached to the safe,
then it can be located on the front or side panel of the box that the safe was
packaged in. Write this number down for future reference.
Clip
Shelf Standard Slots
Adjustable Shelf
Shelf Standard